Power Tools & Accesories

Sander Backing Pad ST-STF D90/7 FX H-HT

For RO 90 DX Maintain a crisp and flat surface especially on edges. (1 piece) Helps to maintain crisp edges and corners High edge strength minimises the risk of sanding edges to a curve Well suited for use on narrow materials Hard version High...

Countersink QLS D 2- 8 CE

Centrotec Pilotless Countersink, D2-8mm. Precision ground. Also compatible with standard 3-jawed chuck. Save time changing between countersink and screw bits with the quick-change Centrotec System Reduce fatigue with the light weight Centrotec chuck...

Spiral Blade HW 65

Spiral cutter engages the material with a slicing action, similar to that of a skewed angle hand plane, generating less chatter and a smoother cut. Self-aligning blades make for quick and easy blade changes - loosen 3 screws, replace the blade,...

Dowel Drill Bit HW S8 D10/30 Z

Dowel and hole series drill with an 8 mm shaft, optimised for high cutting speeds when routing With brad point With brad point

Dowel Drill Bit HW S8 D8/30 Z

Dowel and hole series drill with an 8 mm shaft, optimised for high cutting speeds when routing With brad point With brad point

Dowel Drill Bit HW S8 D6/30 Z

Dowel and hole series drill with an 8 mm shaft, optimised for high cutting speeds when routing With brad point With brad point

Dowel Drill Bit HW D3/16

for OF 900, OF 1000, OF 1010, OF 1010 R, OF 1400 Dowel and hole series drill with an 8 mm shaft, optimised for high cutting speeds when routing Without brad point Without brad point

Spiral groove cutter HS Spi S8 D6/21

For FZ 6 box joint template. For slot joints FZ 6 and open dovetail joints SZO 14 with fine precision in diameter in HS steel runs smoothly

Splinterguard FS-SP 5000/T

Festool FS Guide Rails are available in eight different lengths from 32 inches to 197 inches (800 - 5000 mm), providing the right length for straight, splinterfree cutting in just about any application. The integrated splinterguard is a critical guide...